Obsah
Design PIR 1
Design of plasmatic implosion reactor (PIR) 1 prototype.
- First version of the prototype doesn't need so many sensors. At first the vortex control must be done right
- Later more sensors can come
- Usage of more rotors
- two in both poles (like a galaxy) rotating opposite direction
- Find a way how to use implosive vortex flow for vortex drive
- If we will achieve self-sustaining vortex, then it will have wide use
- It would be nice to start the flow manually from outside
Parts
Chamber
spcherical (later it is possible to try egg-shaped for single motor system)- inner diameter 12 cm
two filling openings in poles of the chamber against each other able to close the opening- by by cork
- by conductor for monitoring or excitation of liquids
- possible solution: plastic sphere two-piece
Chamber stand
Used for 
- storing chamber
- anchor base of the coil
- storing control unit
- chamber lighting
- bringing contacts out of the chamber
Rotor - liquid
Magnetic fluid.
- ferofluid
- iron nanoparticles
- ormus/gans fluid
Stator - coil
Rotor drive. 
toroidal coil out of the chamber.
- double coil pair(bifilar) windings
- one windings can be used for exciting and second for monitoring and connection to oscilloscope
- both windings can be used for exciting and monitoring at the same time
- try concurrent and counterblow current int the windings
- copper stranded wire
- way of winding
- along small perimetr of toroid
- we can try supertoroidal coil with more order spirals
- along big perimetr of toroid
- we can try more order spirals as it is atsubatomic particles ANU even tracks of plants/stars/galaxies…
- exciting
- signal generator
- (arbitrary wave generator) controled by PC with the voltage waveform
- pulse
- PWM (pulse width modulation)
-
- DC up to 1,5 MHz
- duty cycle 0% - 100%
- current up to 9 A
- voltage up to 500 V
-
- frequency up to several MHz
- suitable amplifier, if needed
- possible coil core: styrofoam wreath
Coil pedestal
- Enables vertical positioning horizontaly centered coil
Enables holding and positiong of several coils at once.
Sensors
- Magnetic field near the chamber
- ideally several magnetic sensors
- at least 3 in n-gon in equator
- 2 in every pole
- temperature
- inside at 3 different places
- 2 sensors near poles
- 1 sensor in equator parallel
- around the chamber
- 1 sensor in equator
- ideally in line with center of the chamber and inner equator sensor
- current
- connectors for monitoring voltage between them
- several parallel thin metal strips on inner wall of the chamber
- in poles of axis of rotation of vortex
- ideally connector in center of the chamber
- Must not brake vortex flow
- wire of pole
Control unit
Raspberry Pi 2: 
96 Boards: 
Stand of the chamber is designed to hold both types of the units.
3D model
PC 3D model of the reactor made in PTC Creo Direct Modeling Express, in which it is possible to view and edit it.
I exported each part for 3D printing(STL format):
- Chamber
- Bushing - 2 sets for upper and lower part of the chamber
- Chamber stand
- Coil - 4 parts forming toroid
- Coil stand - 4 parts forming circle
- Coil stand holder - 4 parts plugged in coil stand
Materials and production of the prototype
- Chamber and rotor print on 3D printer from plastics at first
- Chmaber will be ideally transparent
- Silicon seal, if needed